Contact Information
Toll Free
888-335-DACC
- Telephone
225-357-5816
- FAX
225-357-5817
- Postal address
5235 Adams Avenue
Baton Rouge, LA 70806
- Electronic mail
Sales@DACC.com
Copyright © 2009
DACC Industries
All rights reserved.
Information in this document is subject to change without notice.
Other products and companies referred to herein are trademarks or registered
trademarks of their respective companies or mark holders.(DACC
Industries is a Trade Name of LPCII, LLC)
The HL-8A Series of
Tracing Systems
The Linatrol HL-8A series of coordinate
drive tracing systems is available in several different styles
and models, that can be customized to suit your specific applications.
Each system comes with the superior performance of the Linatrol
tracing unit, a highly reliable control unit, and the drive assemblies
necessary to ensure continued operation and reduced downtime.
The system control unit supports
tracing, drive and cutting media controls, as well as up to
6 individual torch lift controls. Power amplifier modules and
circuit cards are located within this unit. Additionally, for
our highest power models - the HL875 & HL876 - an interface
card is supplied for connecting to an external amplifier unit, which
supports both 2 or 3 channel operation. This exceptional product
has been available internationally for over 30 years. With more
than 100 hours of quality control built into each system, it has
become the standard which others strive to attain.
Features and Options
 | Standard oxy-fuel only or Oxy-fuel/plasma
combination controls available.
| Many drive packages to choose
from for speeds up to 10 meters/minute.
| Operator control panel with
controls for gas, tracer, optional plasma and up to 6 individual
torches.
| 24 volt solenoid and torch lift
outputs available.
| Accuracy adjustment to compensate
for line thickness.
| Command Mark slowdown for improved
cornering.
| Automatic pattern acquisition
& bi-directional tracing.
| Torch off-pattern interlock.
| 8 way manual direction control
for straight line cutting & machine repositioning.
| CNC compatible - optional interface
connection.
| Drives available with optional
encoders for CNC operation.
| |
Performance Specifications
| Power: 110/115/230 VAC +10%/-15%,
50/60 Hz, single phase with ground connection.
| Tracing Accuracy: +/- 0.25 mm
deviation from a straight pattern edge.
| Machine Speed: up to 10 meters/minute
(dependent on amplifier output and drive gear ratio).
| Tracing Speed: up to 3 meters/minute.
| Min Corner Radius: square corners
to 1 m/min, 1 mm radius corners up to 1.5 m/min, 3 mm radius
corners up to 3 m/min.
| Kerf Offset: adjustable for
cuts up to 3.0 mm wide (up to 6.0 mm can be supported).
| Lead: 3 mm standard, others
available for special applications.
| Patterns: Silhouette or Line
type (minimum line width is 0.6 mm).
| Environment: operating temperature
0°C to +50°C, storage temperature -18°C to +65°C,
humidity to 95% (non condensing).
| |
