Contact Information
Toll Free
888-335-DACC
- Telephone
225-357-5816
- FAX
225-357-5817
- Postal address
5235 Adams Avenue
Baton Rouge, LA 70806
- Electronic mail
Sales@DACC.com
Copyright © 2009
DACC Industries
All rights reserved.
Information in this document is subject to change without notice.
Other products and companies referred to herein are trademarks or registered
trademarks of their respective companies or mark holders.(DACC
Industries is a Trade Name of LPCII, LLC)
The HL-90 Tracing System
Tracing the Future . . .
The HL-90 Tracing System is a
complete motion control system perfect for small profile cutting
machine applications. The compact tracing unit integrates the
tracer and operator controls for ease of operation and provides
output connections for two drive units as well as a connection
to initiate cutting. By employing advanced signal processing technology
and a patented rotary scanning device, the HL-90 provides consistent,
dependable motion control for high quality profile cutting. With
over 40 years of experience behind us, get Linatrol know-how
working for you and start tracing the future . . . today!
Features and Options
 | Universal compact design to
suit all small machines.
| All operation controls on one
panel.
| Standard system supports speeds
up to 1 meter/minute.
| High Power versions to support
speeds up to 3 meters/minute.
| Dual speed range on High Power
systems.
| Enhanced cornering circuitry
for improved low speed tracing on High Power systems.
| Command Mark slowdown option
for improved cornering.
| Kerf adjustment to 3 mm.
| CNC compatible - optional interface
connection.
| Drives available with optional
encoders for CNC operation.
| |
Performance Specifications
| Power: 110/115/230 VAC +10%/-15%,50/60
Hz, single phase with ground connection.
| Tracing Accuracy: +/- 0.25 mm
deviation from a straight pattern edge.
| Machine Speed: 1, 2 or 3 meters/min
may be selected.
| Tracing Speed: square corners
to 1 m/min, 1 mm radius corners up to 1.5 m/min, | 3 mm radius corners up to 3 m/min. Kerf Offset: adjustable for
cuts up to 3.0 mm wide.
| Lead: 3 mm standard, others
available for special applications.
| Patterns: Silhouette or Line
type (minimum line width is 0.6 mm).
| Environment: operating temperature
0°C to +50°C, storage temperature -18°C to +65°C,
humidity to 95% (non condensing).
| |
